混流泵启动过程进口流动特性的数值模拟

李伟, 马凌凌, 施卫东, 季磊磊, 李恩达

中国机械工程 ›› 2021, Vol. 32 ›› Issue (06) : 666-673,680.

PDF(10081 KB)
PDF(10081 KB)
中国机械工程 ›› 2021, Vol. 32 ›› Issue (06) : 666-673,680. DOI: 10.3969/j.issn.1004-132X.2021.06.005
机械基础工程

混流泵启动过程进口流动特性的数值模拟

  • 李伟1,2;马凌凌1;施卫东3;季磊磊1;李恩达1
作者信息 +

Numerical Simulation of Inlet Flow Characteristics of Mixed Flow Pumps during Start-up

  • LI Wei1,2;MA Lingling1;SHI Weidong3;JI Leilei1;LI Enda1
Author information +
文章历史 +

摘要

通过建立包括叶轮、导叶、蜗壳、阀门、稳压罐及管路在内的全三维闭合回路模型对混流泵启动过程进行数值模拟,分析了启动过程进口回流的形态及形成原因,研究了回流的轴向长度、轴向速度和圆周速度的分布以及轴向截面回流量、回流面积的变化。研究结果表明,数值模拟与试验结果基本一致,数值计算方法较为可靠。叶片吸力面的流动分离和叶顶间隙泄漏是造成进口回流的主要因素。启动过程中的回流参数均随时间呈现先增大后减小的趋势,主流与回流轴向速度在启动初期呈现对称分布,0.8 s后的回流轴向速度出现非对称分布且离叶轮进口越远非对称分布越明显;受回流排挤,主流轴向速度分布在不同截面呈现不同变化趋势,圆周速度逐渐呈非对称分布,进口管圆截面处平面速度方向逐渐偏离圆周切向,各轴向截面处回流量、回流面积的变化趋势基本一致,每个截面相继出现一个回流面积极大值。

Abstract

Based on an established three-dimensional closed-loop model including impeller, guide vane, volute, valve, surge tank and pipeline,the numerical simulation for the start-up of mixed flow pumps was carried out. The generation reasons for form of reverse flow were analysed. 
The disributions of the axial length, axial and circumferential velocities of reverse flow, the variations of reverse flow rates and reverse flow areas at different axial positions were studied. The results show that the numerical computation results are reliable according to the comparison between test and numerical results. The separation flow of suction surfaces and leakage flow of tip clearances are mainly as the reasons for reverse flows. The each reverse parameter increases first and then decreases with time, the axial velocities of main flow and reverse flow present symmetrical distribution in the early stage of the start-up. After 0.8 s, the axial velocities of the reverse flow appear asymmetric distribution. Additional, the farther away from the impeller inlet, the more obvious the asymmetric distribution is. The axial velocity distribution of the main flow presents different changing tendency at different sections. The circumferential velocity gradually presents asymmetric distribution and the velocity direction at the circular section of the inlet pipe gradually deviates from the tangential direction of the circumference. The tendency of reverse flow rate and area at each axial section are basically consistent, and each section gradually presents a maximum return area. 

关键词

混流泵;启动;闭合回路;瞬态特性;进口回流

Key words

mixed-flow pump; start-up; closed-loop; transient characteristic; inlet reverse flow

引用本文

导出引用
李伟, 马凌凌, 施卫东, 季磊磊, 李恩达. 混流泵启动过程进口流动特性的数值模拟[J]. 中国机械工程, 2021, 32(06): 666-673,680 https://doi.org/10.3969/j.issn.1004-132X.2021.06.005
LI Wei, MA Lingling, SHI Weidong, JI Leilei, LI Enda. Numerical Simulation of Inlet Flow Characteristics of Mixed Flow Pumps during Start-up[J]. China Mechanical Engineering, 2021, 32(06): 666-673,680 https://doi.org/10.3969/j.issn.1004-132X.2021.06.005

参考文献

[1]LIU H, CHEN X, WANG K, et al. Multi-condition Optimization and Experimental Study of Impeller Blades in a Mixed-flow Pump[J]. Advances in Mechanical Engineering, 2016, 8(6):1-9.

[2]LI W, ZHANG Y, SHI W, et al. Numerical Simulation of Transient Flow Field in a Mixed-flow Pump during Starting Period[J]. International Journal of Numerical Methods for Heat & Fluid Flow, 2018, 28(4): 607771.

[3]LI W, ZHOU L, SHI W D, et al. PIV Experiment of the Unsteady Flow Field in Mixed-flow Pump under Part Loading Condition[J]. Experimental Thermal and Fluid Science, 2017, 83:191-199.

[4]TSUKAMOTO H, OHASHI H. Transient Characteristics of a Centrifugal Pump during Starting Period[J]. Journal of Fluid Engineering, 1982, 104(1): 6-13.

[5]TSUKAMOTO H, MATSUNAGA S, YONEDA H. Transient Characteristics of a Centrifugal Pump during Stopping Period[J]. Journal of Fluid Engineering, 1986, 108(4): 392-399.

[6]LEFEBVRE P J, BARKER W P. Centrifugal Pump Performance during Transient Operation[J]. Journal of Fluid Engineering, 1995, 117(2): 123-128.

[7]DAZIN A, CAIGNAERT G,BOIS G. Transient Behavior of Turbomachineries: Applications to Radial Flow Pump Startups[J]. ASME Journal of Fluid Engineering, 2007, 129(11):1436-1444.

[8]钟华舟,朱荣生,王秀礼,等. 启动加速度对核主泵叶轮内部流动的影响[J]. 排灌机械工程学报,2018,36(4): 300-306.

ZHONG Huazhou, ZHU Rongsheng, WANG Xiuli, et al. Influence of Start-up Acceleration on Internal Flow in Impeller of Nuclear Reactor Coolant Pump[J]. Journal of Drainage and Irrigation Machinery Engineering, 2018,36(4):300-306.

[9]陈宗贺,施卫东,张德胜,等.混流泵启动过程空化特性的试验研究[J]. 排灌机械工程学报,2019,37(9): 758-762.

CHEN Zonghe, SHI Weidong, ZHANG Desheng, et al. Experimental Study on Cavitation Characteristics of Mixed-flow Pump during Startup[J]. Journal of Drainage and Irrigation Machinery Engineering, 2019, 37(9):758-762.

[10]李志峰. 离心泵启动过程瞬态流动的数值模拟和实验研究[D]. 杭州: 浙江大学, 2009.

LI Zhifeng. Numerical Simulation and Experimental Study on the Transient Flow in Centrifugal Pump during Starting Period[D].Hangzhou: Zhejiang University, 2009.

[11]张玉良. 离心泵启动过程的瞬态内流和外特性[D]. 杭州: 浙江大学, 2013. 

ZHANG Yuliang. Transient Internal Flow and Performance of Centrifugal Pumps during Startup Period[D].Hangzhou: Zhejiang University, 2013.

[12]刘竹青,朱强,杨魏,等. 双吸离心泵关阀启动过程的瞬态特性研究[J]. 农业机械学报, 2015,46(10):49-53.

LIU Zhuqing, ZHU Qiang, YANG Wei, et al. Transient Characteristics of Double-suction Centrifugal Pump during Starting Period under Shut-off Condition[J]. Transactions of the Chinese Society for Agricultural Machinery, 2015, 46(10):49-53.

[13]黎耀军,朱强,刘竹青, 等. 双吸泵系统开阀过程瞬态特性数值模拟[J]. 农业机械学报, 2015, 46(12):79-86. 

LI Yaojun, ZHU Qiang, LIU Zhuqing, et al. Numerical Simulation on Transient Characteristics of Double-suction Centrifugal Pump System during Opening Valve Processes[J]. Transactions of the Chinese Society for Agricultural Machinery, 2015, 46(12):79-86.

[14]郭广强,张人会,赵万勇, 等.浮潜式消防泵启动过程瞬态特性的数值模拟[J].排灌机械工程学报,2019,37(2):118-123.

GUO Guangqiang, ZHANG Renhui, ZHAO Wanyong, et al. Numerical Simulation of Transient Characteristics of Snorkeling Fire Pump during Startup Process[J]. Journal of Drainage and Irrigation Machinery Engineering, 2019, 37(2):118-123.

[15]李意民. 水泵回流理论与研究[J]. 流体机械,1995,23(9):29-31.

LI Yimin. Study on Reverse Flow Theory of Pumps[J]. Fluid Machinery, 1995, 23(9):29-31.

[16]史宏超,李意民. 离心泵进口回流及其控制的研究[J]. 水泵技术, 2000(3): 27-29.

SHI Hongchao, LI Yimin. Study on Reverse Flow Theory and Control[J]. Pump Technology, 2000(3): 27-29.

[17]TOYOKURA T, KUBOTA N. Studies on Back-flow Mechanism of Turbomachines: Part 1, Back-flow Mechnism to the Suction Side of Axial-flow Impeller Blades[J]. Transactions of the Japan Society of Mechanical Engineers, 1967, 33(249):770-778. 

[18]TOYOKURA T, KUBOTA N, AKAIKE S. Studies on Back-flow Mechanism of Turbomachines: Part 2, Back-flow to the Suction Side of Mixed-flow Impeller Blades[J]. Bulletin of JSME, 1969, 12(50):215-223.

[19]程千,冯卫民,周龙才, 等. 前置导叶对轴流泵马鞍区工况回流涡特性的影响[J]. 农业机械学报, 2016,47(4):8-14.

CHEN Qian, FEN Weimin, ZHOU Longcai, et al. Effect of Inlet Guide Vane on Characteristics of Back Flow Vortex in Hump Region of Axial Flow Pump[J]. Transactions of the Chinese Society for Agricultural Machinery, 2016, 47(4):8-14.

[20]李伟,季磊磊,张扬等. 混流泵启动过程瞬态流场的涡动力学分析[J]. 中南大学学报(自然科学版), 2018, 49(10):122-131.

LI Wei, JI Leilei, ZHANG Yang, et al. The Vortex Dynamics Analysis of the Transient Flow Field at the Starting Process of Mixed-flow Pump[J]. Journal of Central South University(Science and Technology), 2018, 49(10):122-131.

[21]BOLPAIRE S, BARRAND J P. Experimental Study of the Flow in the Suction Pipe of a Centrifugal Impeller: Steady Conditions Compared with Fast Start-up[J]. International Journal of Rotating Machinery, 2002, 8(3):208-240.

[22]朱荣生,欧鸣雄.低比转数双吸离心泵回流问题的CFD研究[J].农业机械学报,2009,40(4):82-85.

ZHU Rongsheng, OU Mingxiong. Simulation of Reverse Flow in Low Specific Speed Double Suction Centrifugal Pump[J]. Transactions of the Chinese Society for Agricultural Machinery, 2009,40(4):82-85.

基金

国家重点研发计划(2020YFC1512405);国家自然科学基金(51679111);江苏省第五期“333高层次人才培养工程”科研项目;江苏省“一带一路”创新合作项目(BZ2020068);江苏高校优势学科建设工程项目; 江苏省现代农业装备与技术协同创新中心项目(4091600014)
PDF(10081 KB)

217

Accesses

0

Citation

Detail

段落导航
相关文章

/