The temperature field model of the train tread braking is established based on the rotating heat source method and uniformly distributed heat source method. Under the basic braking condition that contains uniform deceleration braking, stopping, uniform acceleration starting and uniform speed running, the temperature change curves of the three points, which locate on the tread, 1 mm and 2 mm below the tread respectively, are calculated based on the rotating heat source method and uniformly distributed heat source method. At the same time, under the conditions of different shoe contact areas, different braking power and continuous five basic braking, the variation rules of the temperature change curves of the three points based on the two heat source loading methods are investigated. The calculation results show that for the point on the tread, the calculated temperature and the change characteristics based on the two heat source loading methods are quite different. However with the increase of the distance below the tread, the calculated temperature difference based on the two heat source loading methods decreases rapidly, and for the point 2 mm below the tread, the difference can be approximately ignored. In addition, under the condition of continuous braking, the calculated temperature difference of the three points in a certain braking based on the two heat source loading methods is not related to the previous braking.
ZHANG Jinyu
,
YU Dalian
,
LIN Peng
. Analysis of Temperature Field of Train Tread Braking Based on Rotating Heat Source Method and Uniformly Distributed Heat Source Method[J]. Journal of Mechanical Engineering, 2018
, 54(6)
: 93
-101
.
DOI: 10.3901/JME.2018.06.093
[1] 蓝春红, 吴萌岭, 王勇, 等. 重载货车踏面制动时车轮温度场与应力场研究[J]. 铁道车辆, 2011, 49(7):1-5. LAN Chunhong, WU Mengling, WANG Yong, et al. Research on the temperature field and stress field of wheels at time of tread braking of heavy haul freight cars[J]. Rolling Stock, 2011, 49(7):1-5.
[2] HAIDARI A, HOSSEINI-TEHRANI P. Fatigue analysis of railway wheels under combined thermal and mechanical loads[J]. Journal of Thermal Stresses, 2014, 1(37):34-50.
[3] 关莹, 谢素明, 兆文忠. 踏面制动热-机耦合过程的数值仿真[J]. 大连铁道学院学报, 2003, 24(3):9-12. GUAN Ying, XIE Suming, ZHAO Wenzhong. Numerical simulation of passenger car braking process[J]. Journal of Dalian Railway Institute, 2003, 24(3):9-12.
[4] 张萍, 温泽峰, 吴磊, 等. 不同热流加载方式下车轮踏面制动温度和应力场模拟分析[J]. 润滑与密封, 2013, 38(5):69-74. ZHANG Pin, WEN Zefeng, WU Lei, et al. Temperature and stress field analysis of wheel tread braking process using different heat flux loading modes[J]. Lubrication Engineering, 2013, 38(5):69-74.
[5] 杨智勇, 韩建民, 李志强, 等. 北京地铁10号线制动热响应分析与评估[J]. 北京交通大学学报, 2012, 36(4):159-163. YANG Zhiyong, HAN Jianmin, LI Zhiqiang, et al. Assessment and analysis on thermal response of tread-braking for beijing metro line 10 vehicles[J]. Journal of Beijing Jiaotong University, 2012, 36(4):159-163.
[6] 应之丁, 朱建安, 林建平. 快速重载货物列车踏面制动试验与分析[J]. 同济大学学报, 2010, 38(9):1363-1366. YING Zhiding, ZHU Jianan, LIN Jianping. Test and analysis of wheel tread-braking for fast-heavy-load wagon[J]. Journal of Tongji University, 2010, 38(9):1363-1366.
[7] 应之丁, 李小宁, 林建平, 等. 列车车轮踏面制动温度循环试验与温度场仿真分析[J]. 中国铁道科学, 2010, 31(3):70-75. YING Zhiding, LI Xiaoning, LIN Jianping, et al. The temperature cycle test of wheel tread braking for freight trains and the simulation analysis of the temperature field[J]. China Railway Science, 2010, 31(3):70-75.
[8] 李言义, 宋晓文, 赖森华. 时速100km地铁车辆踏面制动热负荷分析[J]. 铁道车辆, 2009, 47(9):6-7, 25-26. LI Lianyi, SONG Xiaowen, LAI Senhua. Analysis of heat load in tread braking of metro vehicles with the speed of 100 km/h[J]. Rolling Stock, 2009, 47(9):6-7, 25-26.
[9] 陈帅, 吴磊, 张合吉, 等. 踏面制动温升对重载铁路车轮磨耗的影响[J]. 机械工程学报, 2016, 52(18):1-7. CHEN Shuai, WU Lei, ZHANG Heji, et al. Influence of temperature rising of tread braking on wheel wear for heavy haul freight car[J]. Journal of Mechanical Engineering, 2016, 52(18):1-7.
[10] 李金良, 肖楠, 谢基龙. 重载货车车轮踏面制动辐板热应力分析[J]. 机械工程学报, 2012, 48(12):133-138. LI Jinliang, XIAO Nan, XIE Jilong. Thermal stress analysis of the heavy-haul freight car's wheel web plate under the wheel tread braking[J]. Journal of Mechanical Engineering, 2012, 48(12):133-138.
[11] 李芾, 安琪, 刘俊红, 等. 重载货车车轮温度场与应力场研究[J]. 系统仿真学报, 2010, 22(2):344-347, 369. LI Fu, AN Qi, LIU Junhong, et al. Research on temperature and stress field of heavy-haul freight car wheel[J]. Journal of System Simulation, 2010, 22(2):344-347, 369.
[12] ADAMOWICZ A, GRZES P. Three-dimensional FE model for calculation of temperature of a thermosensitive disc[J]. Applied Thermal Engineering, 2013, 50:572-581.
[13] 张金煜, 虞大联, 林鹏. 流场分析在地铁车辆踏面制动温度场仿真中的应用[J]. 铁道机车车辆, 2017, 37(2):106-111. ZHANG Jinyu, YU Dalian, LIN Peng. Simulation analysis of temperature field of subway vehicle tread braking[J]. Railway Locomotive & CAR, 2017, 37(2):106-111.
