机械工程学报 >

2017 , Vol. 53 >Issue 20: 113 - 120

DOI: https://doi.org/10.3901/JME.2017.20.113

运载工程

低温下高速车轮材料滚动磨损与疲劳损伤行为

  • 马蕾 ,
  • 王文健 ,
  • 郭俊 ,
  • 刘启跃
展开
  • 西南交通大学摩擦学研究所 成都 610031
马蕾,女,1987年出生,博士研究生.主要研究方向为轮轨摩擦学.E-mail:sheshuyuan@163.com

收稿日期: 2016-08-22

  修回日期: 2017-01-15

  网络出版日期: 2017-10-20

基金资助

国家自然科学基金资助项目（51475393）。

收起

Rolling Wear and Fatigue Damage Behavior of High-speed Wheel Materials at Low Temperature

  • MA Lei ,
  • WANG Wenjian ,
  • GUO Jun ,
  • LIU Qiyue
Expand
  • Tribology Research Institute, Southwest Jiaotong University, Chengdu 610031

Received date: 2016-08-22

  Revised date: 2017-01-15

  Online published: 2017-10-20

Fold

摘要

利用低温环境轮轨磨损模拟试验装置，研究了高速铁路车轮材料在室温及低温环境下的滚动接触疲劳损伤行为。结果表明：低湿度的低温环境导致车轮材料磨损率、塑性变形及疲劳损伤较室温下明显加重。随试验温度的降低，轮轨摩擦因数、磨损率及表面硬度均呈现先急剧上升后轻微下降趋势。室温工况下磨痕表面有严重的犁沟现象，而低温工况下车轮试样表面以疲劳裂纹及剥落损伤为主。随着温度的降低，磨损形式由氧化磨损、磨粒磨损逐渐向疲劳及粘着磨损转变。车轮材料裂纹主要沿较软的铁素体线扩展，室温下剖面损伤较轻微。低温工况下由于车轮材料发生脆化，珠光体呈现不同于室温下的形貌及分布特性。在低温下，表层裂纹扩展角度及次表层裂纹长度增加，同时表层裂纹易于汇合并产生分支。

关键词： 高速车轮材料; 低温; 磨损; 疲劳损伤; 脆化

本文引用格式

马蕾 , 王文健 , 郭俊 , 刘启跃 . 低温下高速车轮材料滚动磨损与疲劳损伤行为[J]. 机械工程学报, 2017 , 53(20) : 113 -120 . DOI: 10.3901/JME.2017.20.113

Abstract

The rolling contact fatigue damage behaviors of high-speed railway wheel material at room and low temperatures are studied by using wheel/rail rolling wear simulation experiment device under low temperature environment. The results show that the low humidity leads to the increase of wear rate, plastic deformation and fatigue damage at low temperature. With the temperature decreasing, the friction coefficient, wear rate and surface hardness show a sharp rise trend and then slight decline. The ploughing dominates on the wheel surface at room temperature, while fatigue crack and peeling at low temperature. With the decrease of temperature, wear mode changes gradually from oxidation wear, abrasive wear to the fatigue wear and adhesive wear. The crack of wheel roller mainly propagates along the soft ferrite line and the profile damage is mild at room temperature. Due to the embrittlement of wheel material at low temperature, the morphology and distribution characteristics of pearlite is different from that at room temperature. At low temperature, the angle of surface crack and length of subsurface crack increases, moreover, the surface crack merges with adjacent cracks easily and branching occurs.

Key words： high-speed wheel materials; low temperature; wear; fatigue damage; embrittlement

参考文献

[1] 冯宝锐,王元清,石永久. 低温下铁路钢轨钢材断裂韧度KIC的试验研究[J]. 铁道学报,2008(2):83-87. FENG Baorui,WANG Yuanqing,SHI Yongjiu. Experimental study on fracture toughness KIC of rails steel under low temperature conditions[J]. Journal of the China Railway Society,2008(2):83-87.
[2] 周燕,王元清,戴国欣,等. 低温对钢结构疲劳性能影响研究综述[J]. 低温建筑技术,2013(7):5-9. ZHOU Yan,WANG Yuanqing,DAI Guoxin,et al. Status on low temperature fatigue behavior of steel structure[J]. Low Temperature Architecture Technology,2013(7):5-9.
[3] 冯宝锐,王元清,石永久,等. 我国铁路钢轨断裂事故分析及其影响因素[J]. 低温建筑技术,2005,27(4):97-99. FENG Baorui,WANG Yuanqing,SHI Yongjiu,et al. Analysis on fracture accidents and its influencing factors for steel tracks in China[J]. Low Temperature Architecture Technology,2005,27(4):97-99.
[4] TERASHITA Y,TATSUMI M. Analysis of damaged rail weld[R]. Quarterly Report of RTRI,2003,44(2):59-64.
[5] 张志明,李余德,牛延军. 金属材料断裂韧度随温度变化的研究[J]. 力学与实践,2010,32(6):43-48. ZHANG Zhiming,LI Yude,NIU Yanjun. Variation of fracture toughness of metallic materials with temperature[J]. Mechanics in Engineering,2010,32(6):43-48.
[6] 杜万泉,蔡其巩,罗力更. 硅钢解理断裂韧性KIC与温度的关系[J]. 金属学报,1983,19(4):A323-A331. DU Wanquan,CAI Qigong,LUO Ligeng. On the temperature dependence of cleavage fracture toughness of silicon steel[J]. ACTA Metallurgica Sinica,1983,19(4):A323-A331.
[7] 王元清,武延民,石永久,等. 低温对结构钢材主要力学性能影响的试验研究[J]. 铁道科学与工程学报,2005,2(1):1-4. WANG Yuanqing,WU Yanmin,SHI Yongjiu,et al. Experimental study on the main mechanical parameters of building steel under low temperature[J]. Journal of Railway Science and Engineering,2005,2(1):1-4.
[8] WADA T,FUKUDA K. Effect of rolling in low temperature austenite region on strength, ductility and toughness of rail steels[J]. Journal of the Iron and Steel Institute of Japan,1987,73(9):1162-1169.
[9] PARSHIN V A,REJKHART V A. Increase of low temperature rail service reliability[J]. Stal',1993,6:55-58.
[10] LEBEDEV V I,TSAREV V F,MOGIL'NYJ V V,et al. Experience of railroad rail production intended for service at low temperatures[J]. Stal',1997,12:26-27.
[11] YUR'EV A B,GODIK L A,KOZYREV N A,et al. Using nitrovan alloy in the production of low-temperature rail steel[J]. Steel in Translation,2008,38(9):756-758.
[12] 曹昱澎,惠虎,轩福贞,等. 基于Master Curve方法的16MnR钢韧脆转变区断裂韧性研究[J]. 压力容器,2008,25(12):10-13,21. CAO Yupeng,HUI Hu,XUAN Fuzhen,et al. Study on fracture of 16MnR steel in the transition-temperature region using the Master Curve method[J]. Pressure Vessel Technology,2008,25(12):10-13,21.
[13] MOSKOVIC R. Modelling of fracture toughness data in the ductile to brittle transition temperature region by statistical analysis[J]. Engineering Fracture Mechanics,2002,69(4):511-530.
[14] EKBERG A,KABO E. Fatigue of railway wheels and rails under rolling contact and thermal loading-an overview[J]. Wear,2005,258:1228-1300.
[15] WANG W J,LEWIS R,YANG B,et al. Wear and damage transitions of wheel and rail materials under various contact conditions[J]. Wear,2016,362-363:146-152.
[16] HE C G,HUANG Y B,MA L,et al. Experimental investigation on the effect of tangential force on wear and rolling contact fatigue behaviors of wheel material[J]. Tribology International,2015,92:307-316.
[17] DING H H,FU Z K,WANG W J,et al. Investigation on the effect of rotational speed on rolling wear and damage behaviors of wheel/rail materials[J]. Wear,2015,330-331:563-570.
[18] 陶功权,王衡禹,赵鑫,等. 基于轮轨关系的车轮踏面损伤机理研究[J]. 机械工程学报,2013,49(18):23-29. TAO Gongquan,WANG Hengyu,ZHAO Xin,et al. Research on wheel tread damage mechanism based on interaction of wheel and rail[J]. Journal of Mechanical Engineering,2013,49(18):23-29.
[19] 李伟,温泽峰,吴磊,等. 车轮滑动时钢轨热弹塑性有限元分析[J]. 机械工程学报,2010,46(10):95-101. LI Wei,WEN Zefeng,WU Lei,et al. Thermo-elasto-plastic finite element analysis of rail during wheel sliding[J]. Journal of Mechanical Engineering,2010,46(10):95-101.
[20] 吴磊,温泽峰,金学松. 车轮全滑动轮轨摩擦温升三维有限元分析[J]. 机械工程学报,2008,44(3):57-63. WU Lei,WEN Zefeng,JIN Xuesong. Finite element analysis of wheel/rail frictional temperature during wheel complete slides on rail[J]. Chinese Journal of Mechanical Engineering,2008,44(3):57-63.
[21] 王元清,奚望,石永久. 钢轨钢材低温冲击功的试验研究[J]. 清华大学学报,2007,47(9):1414-1417. WANG Yuanqing,XI Wang,SHI Yongjiu. Experimental study of the impact toughness of rail steel at low temperatures[J]. Journal of Tsinghua University,2007,47(9):1414-1417.
[22] WANG Y Q,ZHOU H,SHI Y J,et al. Mechanical properties and fracture toughness of rail steels and thermite welds at low temperatures[J]. International Journal of Minerals,Metallurgy and Materials,2012,19(5):409-420.
[23] 王文健,刘启跃,朱旻昊. 轮轨材料硬度匹配性能试验研究[J]. 摩擦学学报,2013,33(1):65-69. WANG Wenjian,LIU Qiyue,ZHU Minhao. Hardness matching behavior of wheel/rail materials[J]. Tribology,2013,33(1):65-69.
Options
文章导航

/

〈 〉

版权所有 © 《机械工程学报》编辑部

技术支持：北京玛格泰克科技发展有限公司