Fatigue Life Prediction of SWH Springs Based on Finite Element Method

  • LIU Zhipeng ,
  • ZHOU Jie ,
  • WANG Shilong ,
  • WANG Sibao ,
  • YANG Wenhan
Expand
  • The State Key Laboratory of Mechanical Transmission, Chongqing University, Chongqing, 400044

Received date: 2019-12-25

  Online published: 2021-02-03

Abstract

Aiming at the fatigue failure of SWH springs, the special SWH springs used by UAE companies were introduced as the research object. Firstly, the stress-strain history of the SWH springs was analyzed by finite element simulation, and the stress-strain distribution of the key region was accurately calculated by the sub-model technology. The correctness of the finite element model was verified through static response experiments. The fatigue properties of steel wire material were derived from the tensile test and the Manson model. Finally, the fatigue life of the SWH springs was predicted by combining the stress-strain history and the fatigue life prediction criteria, and the experimental verification was performed. The results show that:when SWH springs are compressed, the maximum stress is located at the outer steel wire of the end position and the outer steel wire is mainly subjected to bending stress, which is consistent with the situation of the fractured outer-layer steel wire at the end of the springs. The errors between the response simulation and the measured value do not exceed 5%; The fatigue life predicted by the SWT criterion is in good agreement with the experimental fatigue life, and the predicted fracture positions are consistent with the actual fracture positions.

Cite this article

LIU Zhipeng , ZHOU Jie , WANG Shilong , WANG Sibao , YANG Wenhan . Fatigue Life Prediction of SWH Springs Based on Finite Element Method[J]. China Mechanical Engineering, 2021 , 32(02) : 141 -146 . DOI: 10.3969/j.issn.1004-132X.2021.02.003

References

[1]王时龙, 任伟军, 周杰, 等. 多股螺旋弹簧的空间曲线模型研究[J]. 中国机械工程, 2007,18(11):1269-1272.
WANG Shilong, REN Weijun, ZHOU Jie, et al. Research on Spatial Curve Model of Multi-Strand Coil Springs[J]. China Mechanical Engineering, 2007,18(11):1269-1272.
[2]萧红, 王时龙, 周杰, 等. 多股簧的设计计算及有限元仿真分析[J]. 重庆大学学报, 2011, 34(7):20-27.
XIAO Hong, WANG Shilong, ZHOU Jie, et al. Design Calculation and Finite Element Simulation Analysis of Stranded Wire Helical Springs[J]. Journal of Chongqing University, 2011, 34(7):20-27.
[3]洪茂成, 王时龙, 任伟军, 等. 多股螺旋弹簧三维接触摩擦研究[J]. 机械设计与制造, 2008(1):55-57.
HONG Maocheng, WANG Shilong, REN Weijun, et al. Research on 3D Contact Friction of Multi-strand Coil Springs[J]. Machinery Design & Manufacture,2008(1):55-57.
[4]王时龙, 雷松, 蔡振兵, 等. 多股螺旋弹簧扭动微动磨损机理研究[J]. 摩擦学学报, 2011, 31(4):388-396.
WANG Shilong, LEI Song, CAI Zhenbing, et al. Study on the Mechanism of Fretting Wear of Multi-strand Helical Springs[J]. Tribology, 2011,31(4):388-396.
[5]于道文. 多股螺旋弹簧的动应力及其有效寿命[J]. 南京理工大学学报, 1994(3):24-29.
YU Daowen. Dynamic Stress and Effective Life of Multi-strand Coil Springs[J]. Journal of Nanjing University of Science and Technology,1994(3):24-29.
[6]刘森林, 魏志芳, 刘伟, 等. 基于动态特性分析的复进簧寿命预测[J]. 火炮发射与控制学报, 2019, 40(1):1-6.
LIU Senlin, WEI Zhifang, LIU Wei, et al. Life Prediction of Compound Spring Based on Dynamic Characteristics Analysis[J]. Journal of Artillery Launch and Control, 2019, 40(1):1-6.
[7]LLANO-VIZCAYA L D, RUBIO-GONZLEZ C, MESMACQUE G, et al. Multiaxial Fatigue and Failure Analysis of Helical Compression Springs[J]. Engineering Failure Analysis, 2006, 13(8):1303-1313.
[8]DARBAN H, NOSRATI M, DJAVANROODI F. Multiaxial Fatigue Analysis of Stranded-wire Helical Springs[J]. International Journal of Damage Mechanics, 2015, 24(7):1013-1025.
[9]CORMIER N, SMALLWOOD B, SINCLAIR G, et al. Aggressive Submodelling of Stress Concentrations[J]. International Journal for Numerical Methods in Engineering, 1999, 46(6):889-909.
[10]COFFIN L, TAVERNELLI J. Experimental Support for Generalized Equation Predicting Low Cycle Fatigue[J]. Transactions of the American Society of Mechanical Engineers (ASME), Journal of Basic Engineering, 1962, 84: 533-537.
[11]RICOTTA M. Simple Expressions to Estimate the Manson-Coffin Curves of Ductile Cast Irons[J]. International Journal of Fatigue, 2015, 78: 38-45.
[12]BROWN M W, MILLER K. A Theory for Fatigue Failure under Multiaxial Stress-strain Conditions[J]. Proceedings of the Institution of Mechanical Engineers, 1973, 187(1):745-755.
[13]PELLINGHELLI D, RIBOLI M, SPAGNOLI A. Full-model Multiaxial Fatigue Life Calculations with Different Criteria[J]. Procedia Engineering, 2018, 213: 126-136.
[14]KONG Y S, ABDULLAH S, SCHRAMM D, et al. Optimization of Spring Fatigue Life Prediction Model for Vehicle Ride Using Hybrid Multi-layer Perceptron Artificial Neural Networks[J]. Mechanical Systems and Signal Processing, 2019, 122: 597-621.
[15]SMITH R, WATSON P, TOPPER T. A Stress-strain Parameter for the Fatigue of Metals[J]. Journal of Materials, 1970, 5(4):767-778.
[16]KIM K S, CHEN X, HAN C, et al. Estimation Methods for Fatigue Properties of Steels under Axial and Torsional Loading[J]. International Journal of Fatigue, 2002, 24(7):783-793.
Outlines

/

〈 〉