The labyrinth seal in turbomachinery is a key element that restricts leakage flow among rotor-stator clearances from high-pressure regions to low-pressure regions. The fluid-induced forces on the rotor from seals during machine operation must be accurately quantified to predict their dynamic behavior effectively. To understand the fluid-induced force characteristics of the labyrinth seal more fully, the effects of four types of pre-swirls on the leakage, flow field, and fluid-induced force of a rotary straight-through labyrinth gas seal (RSTLGS) were numerically investigated using the proposed steady computational fluid dynamics (CFD) method based on the three-dimensional models of the RSTLGS. The leakage, flow field, and fluid-induced force of the RSTLGS for six axial pre-swirl velocities, four radial pre-swirl angles, four circumferential positive pre-swirl angles, and four circumferential negative pre-swirl angles were computed under the same geometrical parameters and operational conditions. Mesh analysis ensures the accuracy of the present steady CFD method. The numerical results show that the four types of pre-swirls influence the leakage, flow field, and fluid-induced force of the RSTLGS. The axial pre-swirl velocity remarkably inhibits the fluid-induced force, and the circumferential positive pre-swirl angle and circumferential negative pre-swirl angle remarkably promote the fluid-induced force. The effects of the radial pre-swirl angle on the fluid-induced force are complicated, and the pressure forces and viscous forces show the maximum or minimum values at a specific radial pre-swirl angle. The pre-swirl has a negligible impact on the leakage. The four types of pre-swirls affect the leakage, flow field, and fluid-induced force of the RSTLGS to varying degrees. The pre-swirl is the influence factor affecting the leakage, flow field, and fluid-induced force of the RSTLGS. The conclusions will help to understand the fluid-induced force of labyrinth seals more fully, by providing helpful suggestions for engineering practices and a theoretical basis to analyze the fluid-structure interaction of the seal-rotor system in future research.
Qingfeng Wang
,
Lidong He
. Efects of Four Types of Pre-swirls on the Leakage, Flow Field, and Fluid-Induced Force of the Rotary Straight-through Labyrinth Gas Seal[J]. Chinese Journal of Mechanical Engineering, 2019
, 32(3)
: 56
-56
.
DOI: 10.1186/s10033-019-0370-6
[1] S Claire. Gas turbines: a handbook of air, land and sea applications. Oxford, UK: Elsevier, 2015.
[2] S Subramanian, A S Sekhar, B V S S Prasad. On the choice of initial clearance and prediction of leakage flow rate for a rotating gas turbine seal. Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science, 2016, 230(10): 1586-1601.
[3] A Rapisarda, A Desando, E Campagnoli, et al. Rounded fin edge and step position effects on discharge coefficient in rotating labyrinth seals. Journal of Turbomachinery, 2016, 138(1): 011005.
[4] R Flitney. Seals and sealing handbook. Holland: Elsevier, 2014.
[5] Z G Li, J Li, Z P Feng. Labyrinth seal rotordynamic characteristics part I: operational conditions effects. Journal of Propulsion and Power, 2016, 32(5): 1199-1211.
[6] Q F Wang, L D He. Effect and sensitivity analysis of the rotational speed on the fluid-induced force characteristics of the straight-through labyrinth gas seal. High Technology Letters, 2018, 24(11): 62-74.
[7] M Schobeiri. Turbomachinery flow physics and dynamic performance. Germany: Springer-Verlag, 2005.
[8] J M Vance. Machinery vibration and rotordynamics. USA: Wiley, 2010.
[9] C Delebarre, V Wagner, J Y Paris, et al. An experimental study of the high speed interaction between a labyrinth seal and an abradable coating in a turbo-engine application. Wear, 2014, 316(1-2): 109-118.
[10] J Alford. Protection of labyrinth seals from flexural vibration. Journal of Engineering for Power, 1964, 86: 141-147.
[11] G Vannini, M Bertoneri, K K Nielsen, et al. Experimental results and computational fluid dynamics simulations of labyrinth and pocket damper seals for wet gas compression. Journal of Engineering for Gas Turbines and Power, 2015, 138(5): 052501.
[12] A Muszynska. Rotordynamics. USA: CRC Press, 2005.
[13] A Muszynska, D E Bently. Anti-swirl arrangements prevent rotor/seal instability. Journal of Vibration, Acoustics, Stress, and Reliability in Design, 1989, 111(2): 156-162.
[14] G Vannini, C Mazzali, H Underbakke. Rotordynamic computational and experimental characterization of a convergent honeycomb seal tested with negative preswirl, high pressure with static eccentricity and angular misalignment. Journal of Engineering for Gas Turbines and Power, 2016, 139(5): 052502.
[15] N R Morgan, H G Wood, A Untaroiu. Design of experiments to investigate geometric effects on fluid leakage rate in a balance drum seal. Journal of Engineering for Gas Turbines and Power, 2016, 138(7): 072506.
[16] X Z Kong, G W Liu, Y X Liu, et al. Experimental testing for the influences of rotation and tip clearance on the labyrinth seal in a compressor stator well. Aerospace Science and Technology, 2017, 71: 556-567.
[17] F Cangioli, P Pennacchi, G Vannini, et al. Effect of energy equation in one control-volume bulk-flow model for the prediction of labyrinth seal dynamic coefficients. Mechanical Systems and Signal Processing, 2018, 98: 594-612.
[18] F Cangioli, S Chatterton, P Pennacchia, et al. Thermo-elasto bulk-flow model for labyrinth seals in steam turbines. Tribology International, 2018, 119: 359-371.
[19] N M Wang, Y R Wang, A M Tian. Influence of structure parameters on aeroelastic stability for labyrinth seal based on energy method. Propulsion and Power Research, 2018, 7(4): 288-295.
[20] J J Moore. Three-dimensional CFD rotordynamic analysis of gas Labyrinth seals. Journal of Vibration and Acoustics, 2003, 125(4): 427-433.
[21] T Hirano, Z Guo, R G Kirk. Application of computational fluid dynamics analysis for rotating machinery—part Ⅱ labyrinth seal analysis. Journal of Engineering for Gas Turbines and Power, 2005, 127(4): 820-826.
[22] A O Pugachev, U Kleinhans, M Gaszner. Prediction of rotordynamic coefficients for short labyrinth gas seals using computational fluid dynamics. Journal of Engineering for Gas Turbines and Power, 2012, 134(6): 062501.
[23] Z G Li, J Li, X Yan, et al. Numerical investigations on the leakage and rotordynamic characteristics of pocket damper seals—part I effects of pressure ratio, rotational speed, and inlet preswirl. Journal of Engineering for Gas Turbines and Power, 2014, 137(3): 032503.
[24] S Subramanian, A S Sekhar, B V S S Prasad. Rotordynamic characteristics of rotating labyrinth gas turbine seal with centrifugal growth. Tribology International, 2016, 97: 349-359.
[25] L N Butymova, V Y Modorskii. Numerical modeling of the labyrinth seal taking into account vibrations of the gas transmittal unit rotor in aeroelastic formulation. Procedia Engineering, 2017, 201: 666-676.
[26] Z G Li, J Li, Z P Feng. Labyrinth seal rotordynamic characteristics part Ⅱ: geometrical parameter effects. Journal of Propulsion and Power, 2016, 32(5): 1281-1291.
[27] Z G Li, J Li, Z P Feng. Numerical comparisons of rotordynamic characteristics for three types of labyrinth gas seals with inlet preswirl. Proceedings of the Institution of Mechanical Engineers, Part A: Journal of Power and Energy, 2016, 230(7): 721-738.
[28] A Untaroiu, N Morgan, V Hayrapetian, et al. Dynamic response analysis of balance drum labyrinth seal groove geometries optimized for minimum leakage. Journal of Vibration and Acoustics, 2017, 139(2): 021014.
[29] ANSYS. CFX user document, Version 17.0. Europe: ANSYS, 2015.
