机械基础工程

基于WAEEMD和MSB的滚动轴承故障特征提取

展开
  • 1.河北工业大学机械工程学院,天津,300130
    2.Centre for Efficiency and Performance Engineering,University of Huddersfield,Huddersfield,UK,HD1 3DH
郭俊超,男,1992年生,博士研究生。研究方向为旋转机械的故障诊断与状态监测。发表论文10余篇。E-mail:jc_guo12@163.com。

收稿日期: 2020-03-08

  修回日期: 2021-06-18

  网络出版日期: 2021-08-14

基金资助

国家自然科学基金(51875166,U1813222)

Feature Extraction of Rolling Bearings Based on WAEEMD and MSB

Expand
  • 1.School of Mechanical Engineering,Hebei University of Technology,Tianjin,300130
    2.Centre for Efficiency and Performance Engineering,University of Huddersfield,Huddersfield,UK,HD1 3DH

Received date: 2020-03-08

  Revised date: 2021-06-18

  Online published: 2021-08-14

摘要

针对调制信号双谱(MSB)方法仅能处理平稳信号的不足,提出了一种基于加权平均集成经验模态分解(WAEEMD)和MSB的滚动轴承故障特征提取方法。首先,利用WAEEMD将滚动轴承的非平稳振动信号分解成一系列具有平稳特性的固有模态函数(IMF);然后,开发了一种基于Teager能量峭度(TEK)的加权平均方法以强调敏感IMF的重要性,并将加权后的IMF重构为WAEEMD滤波信号;最后,应用MSB分解WAEEMD滤波信号中的调制分量并提取故障特征频率。仿真和实验结果表明,相对于快速谱峭度(FK)和EEMD-MSB方法,WAEEMD-MSB方法能更准确地获取故障特征,从而验证了WAEEMD-MSB方法的有效性。

本文引用格式

郭俊超, 甄冬, 孟召宗, 师占群, 谷丰收 . 基于WAEEMD和MSB的滚动轴承故障特征提取[J]. 中国机械工程, 2021 , 32(15) : 1793 -1800 . DOI: 10.3969/j.issn.1004-132X.2021.15.004

Abstract

Aiming at the facts that the modulation signal bispectrum(MSB) might only process stationary signals, a novel method for fault feature extraction of rolling bearings was proposed based on the WAEEMD and MSB. Firstly, vibration signals of rolling bearings were decomposed into a list of intrinsic mode functions(IMFs) by ensemble empirical mode decomposition(EEMD). Subsequently, the IMFs were reconstructed into the WAEEMD filtered signals using the weighted average method based on Teager energy kurtosis (TEK). Finally, the MSB was used to decompose the modulated components in the WAEEMD filtered signals and extract the fault characteristic frequencies. The analysis results illustrate that the WAEEMD-MSB has a superior performance over fast kurtogram (FK) and EEMD-MSB in extracting bearing fault features.

参考文献

[1]陈雪峰, 张兴武, 曹宏瑞. 智能主轴状态监测诊断与振动控制研究进展[J]. 机械工程学报, 2018, 54(19):58-69.
CHEN Xuefeng, ZHANG Xingwu, CAO Hongrui. Advances in Condition Monitoring, Diagnosis and Vibration Control of Smart Spindles[J]. Journal of Mechanical Engineering, 2018, 54(19):58-69.
[2]CHEN Shiqian, DU Minggang, PENG Zhike, et al. Fault Diagnosis of Planetary Gearbox under Variable-speed Conditions Using an Improved Adaptive Chirp Mode Decomposition[J]. Journal of Sound and Vibration, 2020, 468:115065.
[3]张文颢, 李永健, 张卫华. 基于K-奇异值分解和层次化分块正交匹配算法的滚动轴承故障诊断[J]. 中国机械工程, 2019, 30(4):32-38.
ZHANG Wenhao, LI Yongjian, ZHANG Weihua. Bearing Fault Diagnosis Based on K-SVD and HBW-OOMP[J]. China Mechanical Engineering, 2019, 30(4):32-38.
[4]PACHORI R B, NISHAD A. Cross-terms Reduction in the Wigner-Ville Distribution Using Tunable-Q Wavelet Transform[J]. Signal Processing, 2016, 120:288-304.
[5]CHAUHAN K, REDDY M V, SODHI, R. A Novel Distribution-level Phasor Estimation Algorithm Using Empirical Wavelet Transform[J]. IEEE Transaction Industrial Electron, 2018,65(10):7984-7995.
[6]LIU Zhiliang, ZUO Mingjian, JIN Yaqiang, et al. Improved Local Mean Decomposition for Modulation Information Mining and Its Application to Machinery Fault Diagnosis[J]. Journal of Sound and Vibration, 2017, 397:266-281.
[7]JIANG Xingxing, SHEN Changqing, SHI Juanjuan, et al. Initial Center Frequency-guided VMD for Fault Diagnosis of Rotating Machines[J]. Journal of Sound and Vibration, 2018, 435:36-55.
[8]李心一, 谢志江, 罗久飞. 加窗插值快速傅里叶变换在滚动轴承故障诊断中的应用[J]. 中国机械工程, 2018, 29(10):1166-1171.
LI Xinyi, XIE Zhijiang, LUO Jiufei. Applications of Windowed Interpolation FFT Algorithm in Rolling Bearing Fault Diagnosis[J]. China Mechanical Engineering, 2018, 29(10):1166-1171.
[9]崔玲丽, 王鑫, 王华庆, 等. 基于改进开关卡尔曼滤波器的轴承特征提取方法[J]. 机械工程学报, 2019, 55(7):44-51.
CUI Lingli, WANG Xin, WANG Huaqing, et al. Feature Extraction of Bearing Fault Based on Improved Switching Kalman Filter[J]. Journal of Mechanical Engineering, 2019, 55(7):44-51.
[10]GU Fengshou, WANG Tie, ALWODAI A, et al. A New Method of Accurate Broken Rotor Bar Diagnosis Based on Modulation Signal Bispectrum Analysis of Motor Current Signals[J]. Mechanical Systems and Signal Processing, 2015, 50/51:400-413.
[11]ZHANG Ruiliang, GU Fengshou, HARAM M, et al. Gear Wear Monitoring by Modulation Signal Bispectrum Based on Motor Current Signal Analysis[J]. Mechanical Systems and Signal Processing, 2017, 94:202-213.
[12]TIAN Xiange, GU J X, REHAB I, et al. A Robust Detector for Rolling Element Bearing Condition Monitoring Based on The Modulation Signal Bispectrum and Its Performance Evaluation against the Kurtogram[J]. Mechanical Systems and Signal Processing, 2018, 100:167-187.
[13]WU Z H, HUANG N E, et al. Ensemble Empirical Mode Decomposition:a Noise-assisted Data Analysis Method[J]. Advances in Adaptive Data Analysis, 2011, 1(1):1-41.
[14]PARK S, KIM S, CHOI J H. Gear Fault Diagnosis Using Transmission Error and Ensemble Empirical Mode Decomposition[J]. Mechanical Systems and Signal Processing, 2018, 108:262-275.
[15]胡茑庆, 陈微鹏, 程哲, 等. 基于经验模态分解和深度卷积神经网络的行星齿轮箱故障诊断方法[J]. 机械工程学报, 2019, 55(7):9-18.
HU Niaoqing, CHEN Weipeng, CHENG Zhe, et al. Fault Diagnosis for Planetary Gearbox Based on EMD and Deep Convolutional Neural Networks[J]. Journal of Mechanical Engineering, 2019, 55(7):9-18.
[16]FU Qiang, JING Bo, HE Pengju, et al. Fault Feature Selection and Diagnosis of Rolling Bearings Based on EEMD and Optimized Elman_AdaBoost Algorithm[J]. IEEE Sensors Journal, 2018, 18(12):5024-5034.
[17]CHEN Xihui, CHENG Gang, SHAN Xianlei, et al. Research of Weak Fault Feature Information Extraction of Planetary Gear Based on Ensemble Empirical Mode Decomposition and Adaptive Stochastic Resonance[J]. Measurement, 2015, 73, 55-67.
[18]LEI Yaguo, ZUO Mingjian. Fault Diagnosis of Rotating Machinery Using an Improved HHT Based on EEMD and Sensitive IMFs[J]. Measurement Science and Technology, 2009, 20:125701.
[19]刘永强, 李翠省, 廖英英. 基于EEMD和自相关函数峰态系数的轴承故障诊断方法[J]. 振动与冲击, 2017, 36(2):111-116.
LIU Yongqiang, LI Cuisheng, LIAO Yingying. Bearing Fault Diagnosis Method Based on EEMD and Autocorrelation Function Peak State Coefficient[J]. Journal of Vibration and Shock, 2017, 36(2):111-116.
[20]OSMAN S, WANG W. A Morphological Hilbert-Huang Transform Technique for Bearing Fault Detection[J]. IEEE Transactions on Instrumentation and Measurement, 2016, 65:2646-2656.
[21]DENG Linfei, ZHAO Rongzhen. Fault Feature Extraction of a Rotor System Based on Local Mean Decomposition and Teager Energy Kurtosis[J]. Journal of Mechanical Science and Technology, 2014, 28(4):1161-1169.
[22]LYU Jingxiang, YU Jianbo. Average Combination Difference Morphological Filters for Fault Feature Extraction of Bearing[J]. Mechanical Systems and Signal Processing, 2018, 100:827-845.
[23]ANTONI J. Fast Computation of the Kurtogram for the Detection of Transient Faults[J]. Mechani-cal Systems and Signal Processing, 2007, 21:108-124.
[24]LI Yifan, LIANG Xihui, ZUO Mingjian. Diagonal Slice Spectrum Assisted Optimal Scale Morphological Filter for Rolling Element Bearing Fault Diagnosis[J]. Mechanical Systems and Signal Processing, 2017, 85:146-161.
文章导航

/

〈 〉