工程前沿

预热及保温对严寒环境X80钢管道全自动外焊焊缝组织与性能的影响

展开
  • 1. 中石化江苏油建工程有限公司,扬州, 225009
    2. 哈尔滨工业大学先进焊接与连接国家重点实验室,哈尔滨,150001
汪宏辉,男,1974年生,高级工程师。研究方向为国内外长输管道/场站储罐(油、气、水)焊接工艺设计。发表论文5篇。E-mail:adr400@vip.163.com。

收稿日期: 2020-04-15

  网络出版日期: 2021-04-09

Effects of Preheating and Heat Preservation on Microstructure and Properties of Fully Automatic External Welding Seams of X80 Steel Pipes in Severe Cold Environment

Expand
  • 1. Jiangsu Oilfield Engineering & Construction Company Limited, Sinopec, Yangzhou, Jiangsu,225009
    2. State Key Laboratory of Advanced Welding and Joining, Harbin Institute of Technology, Harbin, 150001

Received date: 2020-04-15

  Online published: 2021-04-09

摘要

研究了-30 ℃严寒环境下采用不同预热及保温措施进行电弧焊接的X80钢,观察了不同焊接条件下接头各区域的显微组织特点,通过硬度测试、拉伸试验、低温冲击试验对接头的力学性能进行了表征。研究结果表明:严寒环境下焊接得到的X80钢焊缝以柱状晶为主,填充区主要由针状铁素体、先共析铁素体及少量魏氏组织组成,随着预热及保温温度升高,魏氏组织的尺寸和数量都有所减小;接头硬度的极大值与极小值分别出现在热影响区的粗晶区与不完全重结晶区,随着预热及保温温度的升高,接头的整体硬度降低,焊缝区域的低温冲击韧性增强,而抗拉强度先提高后降低;预热及保温是接头在严寒环境下获得具有良好综合性能的有效措施,预热及保温温度为100 ℃时接头性能最优。

本文引用格式

汪宏辉, 董淑磊, 钱建康, 汤克刚, 王志航, 秦熙琨, 雷正龙 . 预热及保温对严寒环境X80钢管道全自动外焊焊缝组织与性能的影响[J]. 中国机械工程, 2021 , 32(06) : 748 -755 . DOI: 10.3969/j.issn.1004-132X.2021.06.016

Abstract

X80 pipeline steel arc welded was studied with different preheating and heat preservation measures in -30 ℃ severe cold environment. The microstructure characteristics of each region of the joints were observed under different welding conditions. The mechanics properties of the joints were characterized by hardness tests, tensile tests and low temperature impact tests. The results show that the welding seams of X80 steel welded are mainly columnar crystal in severe cold environment, and the filling areas are mainly composed of acicular ferrite, proeutectoid ferrite and a small amount of Widmanstatten structure. With the increasing of preheating and holding temperature, the size and quantity of Widmanstatten structure decrease. The maximum and minimum values of joint hardness appear in the coarse-grained areas and the incomplete recrystallization areas respectively. With the increasing of preheating and holding temperature, the overall hardness of the joints decreases, the low-temperature impact toughness of the weld areas increases, and the tensile strength increases first and then decreases. Preheating and heat preservation are effective measures to obtain joints with good comprehensive performance in severe cold environment. The joint performance is the best when preheating and holding temperature is as 100 ℃.

参考文献

[1]QIANG Bin, WANG Xin. Ductile Crack Growth Behaviors at Different Locations of a Weld Joint for an X80 Pipeline Steel: a Numerical Investigation Using GTN Models[J]. Engineering Fracture Mechanics, 2019, 213: 264-279.

[2]HAN Y D, JING H Y, XU L Y. Welding Heat Input Effect on the Hydrogen Permeation in the X80 Steel Welded Joints[J]. Materials Chemistry and Physics, 2012, 132(1): 216-222.

[3]LI Shuo, GUO Xiaojiang, LI Yezheng. The Effect of Twice Thermal Cycle on the Microstructure and Mechanical Properties of Coarse Grain Region in X80 Pipeline Steel[J]. Materials Science Forum, 2017, 898: 749-752.

[4]HERMENEGILDO T F C, SANTOS T F A, TORRES E A, et al. Microstructural Evolution of HSLA ISO 3183 X80M (API 5L X80) Friction Stir Welded Joints[J]. Metals and Materials International, 2018, 24: 1120-1132.

[5]许宁, 王峰会, 罗金恒, 等. X80管线钢焊接接头TEM观察下的断裂行为对比[J]. 中国机械工程, 2016, 27(3):403-407.

XU Ning, WANG Fenghui, LUO Jinheng, et al.Comparison of Fracture Behaviors of X80 Pipeline Steel Welded Joints under TEM Observation[J]. China Mechanical Engineering, 2016, 27(3):403-407.

[6]雷正龙,杨雨禾,李福泉,等. X70钢管道全位置激光-MAG电弧复合根焊焊缝成形试验研究[J]. 中国激光, 2015, 42(4):51-57.

LEI Zhenglong, YANG Yuhe, LI Fuquan, et al. Research on Weld Appearance of X70 Steel Joints Prepared by Laser-MAG Hybrid Welding Process for All-position Root Welding[J].Chinese Journal of Lasers, 2015, 42(4):51-57.

[7]曾惠林, 隋永莉, 王俊红. 西气东输二线干线管道冬季焊接技术[J]. 压力容器,2009(6):49-52.

ZENG Huilin, SUI Yongli, WANG Junhong. Reasearch on Welding Technologies in Winter for West-east Gas Pipeline Project II[J]. Pressure Vessel Technology, 2009(6): 49-52.

[8]李建军, 杜则裕, 刘光云, 等. X60管线钢在-20 ℃低温焊接的接头组织性能[J]. 焊接学报, 2010, 31(12): 93-96.

LI Jianjun, DU Zeyu, LIU Guangyun, et al. Welded Joint Properties of X60 Pipeline Steel at -20 ℃[J]. Transactions of the China Welding Institution, 2010, 31(12): 93-96.

[9]肖晓华, 卢东华, 王丰, 等. X80钢低温焊接接头组织与性能研究[J]. 热加工工艺, 2014(13): 169-172.

XIAO Xiaohua, LU Donghua, WANG Feng, et al. Study on Microstructure and Properties of Welded Joint of X80 Steel at Low Temperature[J]. Hot Working Technology, 2014(13): 169-172.

[10]肖晓华, 梁斐珂, 邓龙, 等. 焊接电流对X80钢低温焊接接头组织与性能的影响[J]. 材料导报, 2016, 30(2): 85-89.

XIAO Xiaohua, LIANG Feike, DENG Long, et al. Effect of Welding Current on Microstructure and Properties of Low-temperature Welded Joints of X80 Steel[J]. Materials Review, 2016, 30(2): 85-89.

[11]ZHU Chenxiao, TANG Xinhua, HE Yuan, et al. Effect of Preheating on the Defects and Microstructure in NG-GMA Welding of 5083 Al-alloy[J]. Journal Materials Processing Technology, 2018, 251: 214-224.

[12]刘恒, 高惠临. 焊接预热温度对X80级管线钢组织性能的影响[J]. 焊管, 2007,30(3): 27-29.

LIU Heng, GAO Huilin. Effect of Preheating Temperature at Organization and Performance of X80 Pipeline Steel[J]. Welded Pipe and Tube, 2007,30(3): 27-29.

[13]TURICHIN G, KUZNETSOV M, POZDNYAKOV A, et al. Influence of Heat Input and Preheating on the Cooling Rate, Microstructure and Mechanical Properties at the Hybrid Laser-arc Welding of API 5L X80 Steel[J]. Procedia CIRP, 2018, 74:748-751.

[14]COOPER R, SILVA J H F, TREVISAN R E. Influence of Preheating on API 5L-X80 Pipeline Joint Welding with Self-shielded Flux-cored Wire[J]. Welding International, 2005, 19(11): 882-887.

[15]李亚江. 焊接冶金原理[M]. 北京: 化学工业出版社, 2007.

LI Yajiang. Principle of Welding Metallurgy[M]. Beijing: Chemical Industry Press, 2007.

[16]李为卫, 冯耀荣, 高惠临. X80管线钢不同组织形态的显微结构特征研究[J]. 石油管材与仪器, 2015, 1(1): 36-42.

LI Weiwei, FENG Yaorong, GAO Huilin. Study on the Feature of X80 Pipeline Steel Microstructural Morphologies[J]. Petroleum Instruments, 2015, 1(1): 36-42.

[17]AN Teng, ZHANG Shuai, FENG Min, et al. Synergistic Action of Hydrogen Gas and Weld Defects on Fracture Toughness of X80 Pipeline Steel[J]. International Journal of Fatigue, 2019,120: 23-32.

[18]BATAEV I A, BATAEV A A, BUROV V G, et al. Structure of Widmanstatten Crystals of Ferrite and Cementite[J]. Steel in Translation, 2008, 38(8): 684-687.

[19]CI Ying, ZHANG Zhanzhan. Simulation Study on Heat-affected Zone of High-strain X80 Pipeline Steel[J]. Journal of Iron and Steel Research, International, 2017, 24(9): 966-972.

[20]YANG Yonghe, SHI Lei, XU Zhen, et al. Fracture Toughness of the Materials in Welded Joint of X80 Pipeline Steel[J]. Engineering Fracture Mechanics, 2015, 148:337-349.
文章导航

/

〈 〉