由于机械强度和发电机容量等限制,当超过额定风速后小型风力机的输出功率值会不断增大,因此需要采取有效措施控制输出功率。设计了一种具有功率调节功能的水平轴可变偏心距风力机,并对单台1.5 kW可变偏心距风力机样机进行了流场数值模拟及风洞试验。研究结果表明:随着偏心距的增大风轮内外表面最大压力向一侧集中分布,风力机后方速度的亏损程度逐渐降低;当超过额定风速12 m/s后,风力机发生左右偏心可使输出功率值减小,当风速为15 m/s、偏心距为75 mm时,左右偏心所对应的最低输出功率分别为1 353 W和1 539 W,调控误差分别为9.8%和2.6%。上述结果充分验证了可变偏心距风力机功率控制的可行性,同时也为风力机电控系统的设计提供了理论及试验依据。
Due to limitations of mechanical strength and the generator capacity, the output power values of small wind turbines would continue to rise when the rated wind speed was exceeded, therefore, it was necessary to take effective measures to control the output powers. A horizontal axis variable eccentricity wind turbine with power regulation function was designed. And the numerical simulation of flow fields and wind tunnel tests of a single 1.5 kW variable eccentricity wind turbine prototype were carried out. The results show that with the increasing of eccentricity, the maximum pressures of the inner and outer surfaces of the wind wheels are concentrated on one side, the speed loss degree at the rear of the wind turbines is gradually reduced. When the rated wind speed of 12 m/s is exceeded, the wind turbine with left and right eccentricity may reduce the output power values. When the wind speed is as 15 m/s, the eccentricity is as 75 mm, the minimum output power values corresponding to the left and right eccentricity are as 1 353 W and 1 539 W respectively, and the regulatory errors are as 9.8% and 2.6% respectively. The above results fully verify the feasibility of variable eccentricity wind turbine power control, and also may provide theoretical and experimental basis for the design of wind electromechanical control systems.
[1]郭鑫. 风力发电机可靠性及其增长技术研究[D].吉林市:东北电力大学,2016.
GUO Xin.Study on the Reliability of Wind Turbines and Growth Technology[D].Jilin City:Northeast Electric Power University,2016.
[2]KANEV S.Dynamic Wake Steering and Its Impact on Wind Farm Power Production and Yaw Actuator Duty[J]. Renewable Energy,2020,146:9-15.
[3]VAN D,BAKER D,JAGER D. Wind Turbine Safety and Function Test Report for the ARE 442 Wind Turbine[R].Washington D C:National Renewable Energy Laboratory,2010.
[4]LUBITZ W D.Impact of Ambient Turbulence on Performance of Small Wind Turbine[J].Renewable Energy,2014,61:69-73.
[5]BRENT S.Small Wind Turbine Performance in Western North Carolina[R].Carolina:Appalachian State University,2005.
[6]MARWAN B,CHEN D,HARB M,et al. A Hybrid Model of a Small Auto Furling Wind Turbine[J].Journal of Vibration and Control,2001,7(1):127-148.
[7]LEE H, LEE D J. Wake Impact on Aerodynamic Characteristics of Horizontal Axis Wind Turbine under Yawed Conditions[J].Renewable Energy,2019,136:383-392.
[8]李常春,包道日娜,冯国英,等.小型水平轴变偏心距风力机功率调节方法研究[J].太阳能学报,2018,39(9):2530-2535.
LI Changchun,BAO Daorina,FENG Guoying,et al.Research on Power Regulation Method of Small Horizontal Axis Wind Turbine with Variable Eccentricity[J].Acta Energiae Solaris Sinica,2018,39(9):2530-2535.
[9]孙丰,汪建文,刘雄飞,等.重力回位型风力机限速机理的分析[J].太阳能学报,2017,38(1):1-6.
SUN Feng,WANG Jianwen,LIU Xiongfei,et al. Analysis of the Speed Limit Mechanism of Gravity Back Wind Turbine[J].Acta Energies Solaris Sinica,2017,38(1):1-6.
[10]艾超,陈立娟,孔祥东,等.液压型风力发电机组风力机特性模拟[J].中国机械工程,2015,26(11):1527-1531.
AI Chao,CHEN Lijuan,KONG Xiangdong, et al. Characteristics Simulation for Hydraulic Wind Turbine[J].China Mechanical Engineering,2015,26(11):1527-1531.
[11]叶昭良,王晓东,尹佐明,等.动态偏航过程中风轮非定常气动特性研究[J].工程热物理学报,2019,40(3):565-572.
YE Zaoliang,WANG Xiaodong,ZUO Yiming,et al. Unsteady Aerodynamic Characteristics of Wind Turbine under Dynamic Yaw[J].Journal of Engineering Thermophysics,2019,40(3):565-572.
[12]缪维跑,李春,阳君,等.偏航尾迹特性及对下游风力机的影响研究[J].太阳能学报,2018,39(9):2462-2469.
LIAO Weipao,LI Chun,YANG Jun. Characteristics of a Yawed Wake and Its Influence on Downstream Wind Turbine[J].Acta Energies Solaris Sinica,2018,39(9):2462-2469.
[13]李常春,刘志璋,高晨鸣,等.小型风力机风轮主动侧偏限速方法的研究[J].太阳能学报,2013,34(7):1228-1233.
LI Changchun,LIU Zhihang,GAO Chenming,et al. Study on Tail Furl Control of Small Wind Turbine[J].Acta Energies Solaris Sinica,2013,34(7):1228-1233.
[14]LIU S H,LUO X W,EGUCHI H,et al. An Experimental Study on Self-output-control Chara cteristics of Micro Downwind Rotor with Coning Soft Blades[J].Science China Technological Sciences,2010,53(1):100-104.
[15]李少华,岳巍澎,王东华,等.基于CFD的旋转风轮气动性能分析[J].动力工程学报,2011,31(9):705-708.
LI Shaohua,YUE Weipeng,WANG Donghua,et al. Analysis on Aerodynamic Performance of Rotating Wind Wheels Based on CFD[J].Journal of Chinese Society of Power Engineering,2011,31(9):705-708.
[16]毛晓娥.浓缩风能装置流场仿真与结构优化[D].北京:华北电力大学,2015.
MAO Xiaoe.Flow Field Simulation and Structure Optimization of Concentrated Wind Energy Device[D].Beijing:Northeast Electric Power University,2015.
[17]张利,黄一,陈国达,等.钛合金曲面磨粒流加工扰流流道仿真与试验研究[J].中国机械工程,2019,30(5):519-527.
ZHANG Li,HUANG Yi,CHEN Guoda,et al. Simulation and Experimental Investigation of Disturbance Flow Channels for Abrasive Flow Machining of Titanium Alloy Surfaces[J].China Mechanical Engineering, 2019,30(5):519-527.