Currently, the measurement methods for pneumatic system leakage include bubbling, ultrasonic, and pressure detection methods. These methods are sensitive to high-precision sensors, long detection times, and stable external environments. The traditional differential pressure method involves severe differential pressure fluctuations caused by environmental pressure fluctuations or electromagnetic noise interference of sensors, leading to inaccurate detection. In this paper, a differential pressure fitting method for an asymmetric differential pressure cylinder is proposed. It overcomes the limitation of the detection efficiency caused by the asynchronous temperature recovery of the two chambers in the asymmetric differential pressure method and uses the differential pressure substitution equation to replace the differential calculation of the differential pressure. The improved differential pressure method proposes an innovation based on the detection principle and calculation method. Additionally, the influence of the parameters in the differential pressure substitution equation on the leakage calculation results was simulated, and the specific physical significance of the parameters of the differential pressure substitution equation was explained. The experiments verified the fitting effect and proved the accuracy of this method. Compared with the traditional differential pressure method, the maximum leakage deviation of inhibition was 0.5 L/min. Therefore, this method can be used to detect leaks in air tanks.
Yan Shi
,
Jiaqi Chang
,
Yixuan Wang
,
Xuelin Zhao
,
Qingzhen Zhang
,
Liman Yang
. Gas Leakage Detection and Pressure Difference Identification by Asymmetric Differential Pressure Method[J]. Chinese Journal of Mechanical Engineering, 2022
, 35(2)
: 44
-44
.
DOI: 10.1186/s10033-022-00697-1
[1] Y Shirato, W Ohnishi, H Fujimoto, et al. Controller design of mass flow rate loop for high-precision pneumatic actuator. 16th International Workshop on Advanced Motion Control (AMC), 2020.
[2] Cong-Minh Ho, Duc-Thien Tran, Kyoung-Kwan Ahn. Adaptive sliding mode control based nonlinear disturbance observer for active suspension with pneumatic spring. Journal of Sound and Vibration, 2021: 509.
[3] D Haraguchi, T Kanno, K Tadano, et al. A pneumatically driven surgical manipulator with a flexible distal joint capable of force sensing. IEEE/ASME Transactions on Mechatronics, 2015, 20(6): 2950–2961.
[4] X Liu, J Liu, S Li, Parameter modification model of fluid flow rate for a pneumatically-actuated PDMS membrane microvalve. 2015 International Conference on Fluid Power and Mechatronics (FPM), 2015: 700–705.
[5] W Tao, X Wang, W Bo, et al. Gas leak location method based on annular ultrasonic sensor array. 2018 IEEE International Instrumentation and Measurement Technology Conference (I2MTC), 2018.
[6] D Wang, F Zhao, T Wang. The ultrasonic characteristics study of weak gas leakage. 2015 International Conference on Fluid Power and Mechatronics (FPM), 2015.
[7] G R Piazzetta, R Flesch, A Pacheco. Leak detection in pressure vessels using ultrasonic techniques. ASME 2017 Pressure Vessels and Piping Conference, 2017.
[8] L Zhao, T Wang, P Shi, et al. A novel adaptive leak diagnosis and localization method for infrared image. International Journal of Innovative Computing Information & Control, 2012, 8(5B): 3553–3563.
[9] C C Daniels, M J Braun, H A Oravec, et al. Leak rate quantification method for gas pressure seals with controlled pressure differential. Journal of Spacecraft and Rockets, 2017, 54(6): 1228–1234.
[10] H L Guntur, M Cai, K Kawashima, et al. Analysis of temperature effect on differential pressure method for air leak detection. SICE Conference, 2004.
[11] M Cai, K Kawashima, T Kagawa. Characteristics of leak detection based on differential pressure measurement. Proceedings of the JFPS International Symposium on Fluid Power, 2005.
[12] L G Harus, M Cai, K Kawashima, et al. Determination of temperature recovery time in differential-pressure-based air leak detector. Measurement Science & Technology, 2006, 17(2): 411–418.
[13] L G Harus, M Cai, K Kawashima, et al. The effect of temperature recovery time on the repeatability of a differential pressure type air leak tester. Transactions of the Japan Hydraulics & Pneumatics Society, 2007, 38(4): 54–59.
[14] J Feng Jian, H Zhang, Oil pipeline leak detection and location using double sensors pressure gradient method. Fifth World Congress on Intelligent Control and Automation, 2004, 4: 3134–3137.
[15] S Chen, Y Sun, L Wang, et al. Development on dynamic pressure monitoring method and sensor for long pipeline leak detection. International Pipeline Conference. 2008.
